Type Image transfer accessory compatible with IEEE 802.11a, IEEE 802.11b, IEEE 802.11g wireless LAN and Ethernet (wired LAN) (IPsec-compatible). Can be connected via USB to external media, GPS devices and Bluetooth units.
Compatible Cameras EOS-1D Mark IV These design specification details apply when attached to EOS-1D Mark IV.
EOS-1Ds Mark III*, EOS-1D Mark III* *Requires an update to firmware compatible with EOS-1Ds Mark III. After this, specifications are equivalent to those of WFT-E2A with the addition of IEEE 802.11a wireless networking.
FTP Transfer Transfer images over a network to FTP servers
EOS Utility EOS Utility-based control of cameras over a network
WFT Server Browser-based remote capture and downloading of images over a network
Linked Shooting Wirelessly trigger shooting by slave cameras linked to a master camera
Transmission Range Approx. 328 ft. / 100 m from the master camera (when signal strength is favorable)
Camera Connection System extension terminal
Wired Lan Connection Ethernet RJ-45 port
External Device Connection Hi-Speed USB port (for attaching external media, GPS devices, and Bluetooth units) * Devices can be bus-powered.
Power Supply Powered by the camera
Image Transfer Capacity
At normal temperature (73°F/23°C)
At low temperature (32°F/0°C)
Using a fully charged LP-E4.
Under Camera & Imaging Products Association (CIPA) conditions for testing shooting capacity, when using automatic image transfer with images that are approximately 6MB.
Fewer images can be transferred if the wireless LAN transfer rate drops, and for consecutive image transfer over wireless LAN.
Fewer images can be transferred when using bus-powered external media or GPS devices.
If the remaining battery level drops below 19%, captured images cannot be transferred or backed up to external media.
W x H x D 1.0 x 3.8 x 1.3 in./26.0 x 97.7 x 31.8mm