English | Spanish | German | French | Italian | Japanese | Korean | Chinese
Modifications from Ver.3.64 to Ver.3.66
1. Mac OS X v10.7 has been supported.
2. Mac OS X v10.3 is not supported.
Modifications from Ver.3.63 to Ver.3.64
1. MacOSX10.6 SnowLeopard has been supported.
Modifications from Ver.3.61 to Ver.3.63
1. For reducing operation noise at printing further, the control of mechanical structure has been changed partially by adjusting the mechanical control information included in Media Configuration Tool.
Use this MCT after updating the printer firmware to Ver.1.07 or later.
Modifications from Ver.3.60 to Ver.3.61
1. Premium Plain Paper (for borderless printing) has been supported.
The following hardware and software are recommended for this software.
Mac OS X v10.4.11 to v10.7
Requires Administrator access rights.
Any computer running the software listed above.
- Before the installation, close all the other application software.
- Requires Administrator access rights.
- For more about installation the procedure, please refer to the manual.