- iPF710 Firmware Ver.1.40 (Firmware Update Tool Ver.3.40) for Windows x64
: 0400012902_EN_6
You can use this program to update the printer firmware version.
  • Windows 7 (x64)
  • Windows Vista (x64)
  • Windows XP (x64)
  • Windows Server 2003 (x64)
  • Windows Server 2003 R2 (x64)
  • Windows Server 2008 (x64)
  • Windows Server 2008 R2 (x64)
iPF710-FUT-Win64-140.exe
1.40
14.44 MB
English | Spanish | German | French | Italian | Japanese | Korean | Russian | Chinese
12/16/2010
Modifications from Ver.1.37
a) The fairly infrequent problem of printer not being able to retrieve from sleep mode has been fixed. 
b) The drive control in printing optimized 
Use this program with the systems and the operating environments below.

  Software:   Microsoft Windows 7 64-bit edition, English Edition
              Microsoft Windows Server 2008 R2 64-bit edition, English Edition
              Microsoft Windows Server 2008 64-bit edition, English Edition
              Microsoft Windows Vista 64-bit edition, English Edition
              Microsoft Windows Server 2003 R2 64-bit edition, English Edition
              Microsoft Windows Server 2003 64-bit edition, English Edition
              Microsoft Windows XP Professional 64-bit edition, English Edition

  Hardware:   Any computer running the software listed above.

 Interface Connectivity:
  The printer and computer where this program is executed must be connected 
  with either of the following methods.

  - Connected via a TCP/IP network and capable of printing via the network.
  - Connected via a USB or IEEE 1394 port cable and capable of printing 
    as a local printer.

  Note: If you are using IEEE1394, IEEE1394 Class Driver is needed.
-  You must log into Windows as an Administrator before the installation.
-  before You start the firmware version update program, close any other applications that are running.
-  Do not try to use the printer while the firmware version update program is running.
   If a print job is executing, cancel the print job or wait for the job to finish before You execute the version update program.
-  Never switch off the target printer while the firmware version update program is running.
-  If the firmware version update fails while writing to the flash ROM,
   You may not be able to start the printer. In this case, contact a Canon service center or the dealer where You purchased the printer.
(1) Switch the printer on.
(2) Decompress it on your computer hard disk.
(3) Execute the setup file. The imagePROGRAF Firmware Update Tool is installed.
(4) From the Start menu, select Programs to execute imagePROGRAF Firmware Update Tool.