Details - iPF810/iPF820 Firmware Ver.1.11 (Firmware Update Tool Ver.3.50) for Mac OS X v10.6-v10.8
ID: 0400024602_EN_7
You can use this program to update the printer firmware version.

How to Download and Install
(1) Switch the printer on.
(2) Decompress it on your computer hard disk.
(3) Execute the imagePROGRAF FirmUpdate file. 
    The imagePROGRAF Firmware Update Tool is installed.
(4) Execute the installed imagePROGRAF Firmware Update Tool.
Driver/Software Details
File Name
File Version
File Size
17.54 MB
File Languages
English | Spanish | German | French | Italian | Japanese | Korean | Chinese
Post Date
Modifications from Ver.1.10 to Ver.1.11
1. The problem that the community name setting in SNMP setting was not processed correctly has been fixed.

Modifications from Ver.1.09 to Ver.1.10
1.The automatic maintenance operation of printhead has been optimized.

Modifications from Ver.1.06 to Ver.1.09
1. The specification for leading edge feeding for Premium Plain Paper has been changed.
      Install Media Confuguration Tool Ver.3.42(Windos)/3.43(MacOSX), and run it to add the media information.
2. The error of file name in FTP printing has been fixed.
3. The problem in the recovery operation in paper-out condition has been fixed.
4. In HP-GL2, a lower roll paper has been added to the paper feed slot.  

Modifications from Ver.1.04 to Ver.1.06
1.The problem that a printing failure would occur in some CAD applications depending of the setting has been fixed.
2.The problem that "2F26" error would be indicated in rare cases when using the paper width detection "OFF" has been fixed.

Modifications from Ver.1.03 to Ver.1.04
1. In case the nozzles are clogged, formerly you would stop printing and check the printout, and then continue printing by pressing the Online key.  
Now it automatically checks the level of clogging, and if it is possible to print it will continue printing,
and if it needs a printhead replacement, it will display a Replace Printhead message.
2.This modification will greatly improve the workability. 
- [Paper Details]/[Return Defaults] function has been fixed.
- Some functions in the HP-GL/2 have been improved.
  Mac OS X v10.6-v10.8, English edition

  The softwares above require the Intel processor or PowerPC of the 
  Macintosh Series computers.

Interface Connectivity:
  The printer and computer where this program is executed must be connected 
  with either of the following methods.

  - Connected via an Bonjour and capable of printing via the network. 
  - Connected via a USB or FireWire port cable and capable of printing as a local printer.
*  Before you start the firmware version update program, close any other applications 
   that are running.

*  Before executing the firmware update of a printer connected to the network, 
   make sure AppleTalk is selected "Active".

*  Do not try to use the printer while the firmware version update program is running. 
   If a print job is executing, cancel the print job or wait for the job to finish 
   before you execute the version update program.

*  Never switch off the target printer while the firmware version update program is running.

*  If the firmware version update fails while writing to the flash ROM, 
   you may not be able to start the printer. In this case, 
   contact a Canon service center or the dealer where you purchased the printer.
Downloads are not available as your browser JavaScript setting is disabled. Please enable your browser JavaScript setting to download the file.