iPF6300S-FUT-Win-106.exe

1.06

30.33 MB

English | Spanish | German | French | Italian | Japanese | Korean | Russian | Chinese

01/19/2013

Modifications from Ver.1.05 to Ver.1.06
1. Optimized the control of the print head.
2. The problem that the community name setting in SNMP setting was not processed correctly has been fixed.
3. Fixed the issue that the illustration of the release lever is displayed on LCD even though it does not exist.
4. Shutdown timer function has been added.
-Shutdown timer
After the printer goes into Sleep Mode, power will be turned off automatically when the situation that the printer is not operated continues until the time being set in advance by operation panel.
Setup time:OFF/ 5 min./ 10 min./ 30 min./ 1 hour/ 4 hours/ 8 hours*/ 12 hours *Initial value when updating version.

Modifications from Ver.1.04 to Ver.1.05
1. The control of waste ink has been optimized.
2. The infrequent failure that a job sent during transition to sleep mode might be cancelled has been fixed.
3. The fairly infrequent failure of printer not retrieving from sleep mode has been fixed.

Modifications from Ver.1.01 to Ver.1.04
1.Modifications due to parts change
2.The fairly infrequent failure of printer not retrieving from sleep mode has been fixed.

Use this program with the systems and the operating environments below.

  Software:   Microsoft Windows 8 32-bit edition, English edition
              Microsoft Windows 7 32-bit edition, English edition
              Microsoft Windows Server 2008 32-bit edition, English edition
              Microsoft Windows Vista 32-bit edition, English edition
              Microsoft Windows Server 2003 R2 32-bit edition, English edition
              Microsoft Windows Server 2003 32-bit edition, English edition
              Microsoft Windows XP Professional / Home Edition 32-bit edition, English edition
              Microsoft Windows 2000 Professional /Server , English edition

  Hardware:   Any computer running the software listed above.

 Interface Connectivity:
  The printer and computer where this program is executed must be connected 
  with either of the following methods.

  - Connected via a TCP/IP network and capable of printing via the network.
  - Connected via a USB or IEEE 1394 port cable and capable of printing 
    as a local printer.

  Note: If you are using IEEE1394, IEEE1394 Class Driver Ver2.0 or later is needed.

*  You must log into Windows as an Administrator before the installation.
*  Before You start the firmware version update program, close any other applications that are running.
*  Do not try to use the printer while the firmware version update program is running. If a print job is executing, cancel the print job or wait for the job to finish before You execute the version update program.
*  Never switch off the target printer while the firmware version update program is running.
*  If the firmware version update fails while writing to the flash ROM, You may not be able to start the printer. In this case, contact a Canon service center or the dealer where You purchased the printer.

(1) Switch the printer on.
(2) Decompress it on your computer hard disk.
(3) Execute the setup file. The imagePROGRAF Firmware Update Tool is installed.
(4) From the Start menu, select Programs to execute imagePROGRAF Firmware Update Tool.